Common Reasons Why Your Top Load Washer Will Not Spin

The top load washer is one of the most preferred washing machines in most homes due to the ease of loading clothes into the machine. With time and continued usage, your washing machine will experience glitches; therefore, you must be prepared to avoid inconveniences. One common problem with top load washers is that the loader fails to spin at times, thereby making it impossible to clean your clothes. If you have a top load washer and it does not spin, the following might be the possible causes:

Defective Lid Switch -- If you close the lid and the washing machine does not spin, the switch inside may be defective. Since this switch is housed near the washing machine's door frame, it is susceptible to wear and tear. Therefore, you should make an effort of checking the lid switch regularly for any signs of wear. You should do timely replacement of a worn out switch and conform to manufacturer specifications while at it.

Broken Coupler -- In a washing machine, a coupler attaches the shaft to the motor for power and motion transmission purposes. As such, the coupler plays an important role in the spinning process of the washer. As such, any wear and tear will stop the washer from spinning. This is especially true because most couplers are made from plastic or rubber that wears out with time. Therefore, you should check to ensure that the coupler is in good shape and ask a professional to replace it if it is not.

Pressure Switch -- There are times when your washing machine will pump water out but fail to spin. If this happens, then the pressure switch is not functioning optimally. To be sure, you need to inspect the pressure switch. You can do this by first unscrewing the control panel that houses the switch. Once removed, the water level control valve will be visible. To identify the pressure switch, simply look for a plastic tube that is attached to the valve. Go ahead and pull the hose attached to the water level valve then blow air into it. Most times, soapy residue will clog the hose and blowing air into it will partly remove the soapy residue. Finish off by passing vinegar into the hose to clear any remaining soapy debris. However, if the switch is burned or broken, you are better off calling a washing machine repair professional to replace it for you.